How To Get Water Out Of Charging Port Iphone 12. Next, download the “water eject” shortcut from this link and add it to your iphone. Using compressed air is your best bet to clean an iphone charging port, so experts recommend trying this method first.
Next, grab a flashlight and have a. Turn your device back on and try charging the battery. Repeat as needed, and test the port between tries.
Table of Contents
Completely Remove The Tray So That Water Can Escape.
You will need to enter your passcode to confirm the action. Continue to do this until the debris starts to come loose. How to save a wet iphone:
In This Process, You Should Not Shake The Phone Or Blow The Lightning Port.
Firstly, remove all cables and accessories from your iphone and don’t plug them in again until your iphone is completely dry. Sometimes a little wiggle or tap is all you need to dislodge a bit of dirt or grime from. Get all of the excess moisture off with an absorbent cloth.
First, You Need To Enable The Installation Of Untrusted Shortcuts On Your Iphone.
Gently insert the toothpick into the port. Turn off your iphone by going to settings > general > shut down. Tap your iphone gently against your hand with the lightning connector facing down to remove excess liquid.
Disconnect From The Power Source And Power Off If Your Phone Was Plugged In While Taking The Dive, Unplug It.
The next step is to confirm your reset setting. Holding your iphone so the backside is facing up, place the toothpick inside the charging port. Wrap a small piece of absorbent cloth around a toothpick or pin, use this to soak up any water from the charging port, headphone jack, and sim card tray.
To Remove Extra Liquid, Gently Tap Your Iphone On Your Hand With The Lightning Connector Facing Down.
Power down your iphone or ipad. Hold your iphone with the lightning port facing down, then gently tap it with your palm to ease liquid out of the port. If your iphone wont charge there may be some debris stuck inside of the port.
